I was on a trip recently when I lost power. One of the driven sprockets that drive the timing belt broke off. I since have replaced both drive gears and the timing belt. I have properly aligned both drive gears to their respective marks and have aligned the flywheel to 1TDC and double checked...
I wanted to reach out for opinions on what prop I should be running on my boat to reach all around maximum performance. I have an 04 Parker 2320 powered with a F225. I’m currently running a 15x17p prop and run 5300 rpm WOT. Pretty sure I should be in the range of 5800-6000. Your feedback is very...
My boat had an older radar on it so there was already a 1” or 1 1/4” hole drilled dead center on my roof. I had to cut one end off of the radar cable to make it more stream lined to fit through the conduit then crimp a new 8 pin cable connector on. Here is a picture of the garmin grommet I used...
I recently installed a garmin 18HD radar unit on a sea view radar mount and 5 degree wedge. I have an 04 2320 with the conduit. I can take pics if you’d like to see them. I pulled all my wires through the conduit so nothing is exposed at all.
I’m in the process of installing Garmin electronics in my 04 2320. Due to nationwide back order, it has made it difficult to get your hands on certain products. My question involves my radar compliment, I ordered a Garmin 18HD+ due to it being available but know that there is an XHD model as...
I’m looking for a 15 1/2” x 17 pitch stainless Yamaha saltwater series prop right hand rotation. If anyone is looking to get rid of one please let me know. Thank you. Brandon.
Thank you sydngoose, I’ll look into purchasing that color then. Have you by any chance used awlgrip? If so, what primer is needed and what needs to be added to the top coat to activate the paint? Awlgrip seems to have so many products it becomes confusing what will get the job done. Thanks for...
I’m planning on rolling then tipping it with a brush. Not sure if I’m going to end up refinishing the nonskid on the platform or just making a template and finishing it with seadek in place of the original non skid layout. Going to make a few phone calls to see if I can find a match, once I’ve...