Search results

Dutton-Lainson Strongarm SA9000 12 volt electric winch. New, never used. $250.00

For Sale: Captain chairs (2) from a Parker 23SE. Excellent condition. Were replaced by a leaning post. $150.00 each.

How does one determine spindle size? I have an EZ loader tandem trailer (4700#) with torsion axles. Anyone the size of the spindles? Thanks.

I own an EZ-Loader tandem trailer that has torsion axles. Although they appear to be working fine the torsion bars are severely rusted. Any recommendations on when or if they should be replaced. Thank you.

While fishing in the Chesapeake I hit something underwater and took some chunks out of the front of the skeg on my 150 yamaha. There is no oil leakage and I can detect no vibrations. Question: what to do? One repair service, without seeing the motor, said they would pressure test it and if ok...

My trim Indicator on my Yamaha controls (150 4-stroke) does not function properly. The bar stays near the top of the display and oscillates a bit. It continues to do this no matter what trim I place the engine. Any suggestions as to the cause. Thank you.

I'm sure this has been covered before but please indulge me. Is there any concern about mixing gas containing ethanol with non-ethanol gas? I am down to 27 gallons of ethanol gas in my 23se and want now to add non-ethanol gas. Thank you.

I have a 23se which I transport with a bunk trailer. I have difficulty lining up the stern on the trailer when retrieving it at a ramp. I have to be fairly exact or the edge of the trim tabs cuts into the bunk. I'd appreciate any suggestions on ways to align the stern. Thanks.

Our community on the eastern shore of Md. has a marina and a decision has been made to convert from ethanol to non-ethanol fuel. A local marine mechanic has stated in our local newspaper that a mixing of the fuels in a boat's fuel tank could cause engine problems. Is there any validity to his...

I have an EZ-Loader tandem float-on trailer that supports a 23SE with a 150 4-stroke. No T-Top. I noticed that the front tires are wearing more on the inside; the rear tires are wearing evenly. Does anyone have any insight as to why? Thanks.

I own a 2007 23SE that has 2 capt. chairs mounted on a live well. I would like to convert the chairs to a leaning post. From my research I have been able to come up with only one solution: a Todd Universal Leaning Post which would allow me to use my existing pedestals (2 7/8" diameter and about...

I have a 2007 23se with captain chairs for which I need some replacement parts. Does anyone know the manufacturer of these chairs? Thanks.

I have a 23se. The starboard side battery has a tan and green wires. Does anyone know if the green wire is a ground? I believe the tan wire is hot but if anyone knows for sure I'd ge grateful for their input. Thank you, Frank

While traveling rt.13 south on the eastern shore of Va. this afternoon I noticed a 21se or 23se sitting on a trailer with a bimini that enclosed the center console. Does anyone know or have any information re: this? Thanks

Bought a new Parker in Jan. 07 equipped with 150 4-stroke. Now has about thirty hours on it and it has had its 10h service by dealer. Trailered it down to Fla. this month and had a few occasions while running at 3800-4000 rpms that the rpms suddenly dropped. Engine never quit and the rpms...

Over the week-end while fishing the Chesapeake I ran over a pipe in the water leaving a 3 ft. gouge on the bottom of my 23se. In one area the gouge is through the gelcoat to the glass. It is no more than a few millimeters wide. I would appreciate any suggestions on how to repair this defect.

Anyone have any experience with a jackplate on a 23se? If so would appreciate hearing your thoughts. Thanks

I have been offered a new 2007 23SE,however it is fitted with a 150hp engine. The attributes according to the dealer are lighter weight, better balance, better fuel economy and less cost. Most of the time the boat will carry no more than two people and will have no other options over the...