iltfish
Well-known member
Hi guys,
Got a 1999 2520MV with a single Yammi 200 HP with SeaStar hydraulic steering HC 5345 cylinder unit. Have a slight weep from port side of cylinder, so I ordered HS5157 kit to reseal. Instructions seemed pretty simple, but then I got into it. Loosened the gland seal, removed the piston rod nut and support brack nut. Now, I need to remove the support bracket. This is the piece that is between the rod and the engine. :?: This thing won't budge! As I already said, the nut is removed. What is the trick to get this bracket off??
Without this, I cannot fully remove the gland seal to replace.
Please advise ASAP as I need to take care of tomorrow to continue season.
Also, I have a 1.7 helm and would like to remove and clean the check valves. If anyone has an idea how to do this, I'd appreciate some tips!!!
Got a 1999 2520MV with a single Yammi 200 HP with SeaStar hydraulic steering HC 5345 cylinder unit. Have a slight weep from port side of cylinder, so I ordered HS5157 kit to reseal. Instructions seemed pretty simple, but then I got into it. Loosened the gland seal, removed the piston rod nut and support brack nut. Now, I need to remove the support bracket. This is the piece that is between the rod and the engine. :?: This thing won't budge! As I already said, the nut is removed. What is the trick to get this bracket off??
Without this, I cannot fully remove the gland seal to replace.
Please advise ASAP as I need to take care of tomorrow to continue season.
Also, I have a 1.7 helm and would like to remove and clean the check valves. If anyone has an idea how to do this, I'd appreciate some tips!!!