Recent content by boat25

Time to get something smaller. $ 25,900 2000 Parker, 2005 Yamaha HDPI, about 655 hours on O/B. Installed hour meter in 2008 when I purchased the boat. 2-stroke. New electric boat levelers, Porta Poti. Will be in the water in a week or so. Changed all O/B fuel filters every year, water pump in...

Port front window, fixed from 2000 Parker 25. Good shape with inside trim ring. $ 150.00 The only thing I see wrong with glass is salt / hard water spots. Can be polished out with compound. I replaced this with opening port. Basic Dim. 31" wide x 18-1/2 / 19" high. Made by Wynne Enterprises, Al.

Try to cut zinc with die grinder, either with burr or cut off wheel. Try unscrewing while pulling down on zinc with vicegrips .

My 300 Yamaha 2-stroke 2005, will not suck water with water muffs on .Checked impeller and tried again,Impeller good, still no water. Same thing happen last year, I put it in last spring and it did fine. Any answers or help, thanks.

I used the Vetus sliding cable control unit, with the Yamaha 704 controls. It works pretty good, took some time adjusting cables. Two cables run back to a sliding unit and one cable exits out of it to throttle or shifter. It takes 2 sliding units, around $60-70 each.

Looking for used opening port window for 25, 2000 model boat

My boat was prewired with port rocker switch. Single speed with park. Two wires orange & orange w/blk stripe. Didn't know the wires were in the conduit & I drilled small hole at first. And then a step bit for a 1/2 hole. I did scrape one wire , not to bad . 110' wiper looked like it would give...

Just another message. My port wiper switch was prewired in the conduit. If you have that also running across the overhead just drill into where you want the wire to come out but be carefull , you don't nick the wire with the drill bit . With a pair of needle nose pliers put the end out. 1 orange...

Just added a wiper AFI 110' & 2-1'2 shaft to 25 parker. parker may have run the extra wire in the overhead or conduit that runs along the cabin top. As it was in my boat 2000 model.

let me know when the pics are in, and where are we shipping them from? Rick

Windows off a 25 ft ? both tilt ? thanks

Hi, did my own second helm, plywood box with glass over and painted. Used a Yamaha single control, so to only have to think about one thing. Teleflex says not to cut fluid lines for steering, but I did and Tee off of them. Saved some money. Just take them to a guy who does hydralics and have...

I'm thinking about doing the same thing. , The Manufacturer of my windows has a web site, Wynne Enterprises. Anyone have a good solution to taking water salt/spots/stains off windows .

I have the Yamaha panel with start & kill switch. Was going to wire right to the back of the cabin switch , but that seems sloppy and kinda hard to reach.

Took one apart , seastar 1.7 it had 5 somewhat spring loaded pumps on a rotating drum , the pumps were stuck, couldn't see anywhere to get those apart. Soaked them for days. Just got anew one on Ebay. Someplace on the west coast I googled repairs them , cost , don't know. The valve body has all...