Parker 1800 fuel pickup part number

Classic Parker Boat Forum

Help Support Classic Parker Boat Forum:

Fintuition

Member
Joined
Jun 22, 2021
Messages
9
Reaction score
0
Hello, when I pump the bulb this fitting makes a hissing gurgling sound I'm assuming it's not supposed to do that? I'm having a fuel pressure issue and hoping replacing this is the fix. Boat is a 94 1800 CC. Looking for a part number. Thanks is advance!
 

Attachments

warthog5

Well-known member
Joined
Feb 23, 2006
Messages
3,513
Reaction score
206
Location
Pensacola, Fl.
THAT.....is a "anti-siphon valve". You remove the fuel hose.....Then unthread that out of the tank......You take it apart and with a small punch and hammer you knock the ball and spring out of it......Then reinstall it. There have been cases where folks had to call Seatow do to the ball being stuck shut...This stopped fuel from getting to the engine.....It is supposed to plug the line should the boat get upside down......But....fuel will leak out the vent if that happens.
 

Watergoat

Active member
Supporting Member
Joined
Aug 29, 2020
Messages
34
Reaction score
4
What does the rest of the tank look like? Have you taken the sending unit out yet ?
 

warthog5

Well-known member
Joined
Feb 23, 2006
Messages
3,513
Reaction score
206
Location
Pensacola, Fl.
replace them......But still knock the ball and spring out of the new one...Use Permitex high performance thread sealant...Not teflon tape,
 

Fintuition

Member
Joined
Jun 22, 2021
Messages
9
Reaction score
0
curious to what the pickup tube looked like
Also......maybe that deck plate needs attention.
Pickup tube looks totally fine no cracking or damage whatsoever. Still replacing with new. I think you're right about the deck plate going to get a new seal for it.
 

tomc585

Well-known member
Joined
Oct 6, 2020
Messages
379
Reaction score
78
Location
Long Island, N.Y.
I removed both my deck plates, epoxied over the exposed end grain, reinstalled with sealant and new o-rings.
And if your really adventurous reseal the risers inside the console that the rigging goes through.
 
Last edited:

Fintuition

Member
Joined
Jun 22, 2021
Messages
9
Reaction score
0
Anyone happen to know a part number for sending unit for my boat? I have so little time to get to the boat these days I'd like to have one on hand to change out next time I get down there and can't find it online
 

warthog5

Well-known member
Joined
Feb 23, 2006
Messages
3,513
Reaction score
206
Location
Pensacola, Fl.
Pull the sender.....after you put witness marks on it and the tank....Measure the tank depth then order the proper depth sender. Not the swing arm style that is in there. A Moller Reed style unit.......Much better stuff.
 

Fintuition

Member
Joined
Jun 22, 2021
Messages
9
Reaction score
0
Pull the sender.....after you put witness marks on it and the tank....Measure the tank depth then order the proper depth sender. Not the swing arm style that is in there. A Moller Reed style unit.......Much better stuff.
I'll do that thank you!
 
Top