Recent content by floundermeister

No trailer. I hope one of the pics attached to this response. If not I will try again later or add additional pocs

I have been comtemplating putting her up for sale as I don't get th use the boat as much as I would like to, so here it is: 1994 Parker 2520 MV Sport Cabin with a full transom and a single bracket. It also has a pulpit with roller, winch, and 2nd station with hydraulic steering. AC/DC...

Went to the one in Virginia Beach yesterday. Talked to Linwood for a while. After looking at the boats, I can say in my opinion, that the Parker's were the best looking boats at the show! He mentioned that possibly the 34 may be included in future shows. Joe

I PM'd you

John, Just read your post. I have an older 94 2520 and keep it at Vining's Landing Marina. Hope you enjoy your Parker. If you are going to trailer the boat, please remember your boat will be over the legal limit and you will have to get an oversize permit for trailering. I had considered...

I believe I paid something like $4.71/gal in Norfolk, VA last week.

In Norfolk, there is Little Creek Marina and Vinings Landing Marina. They are both located in Little Creek (across the inlet from each other) and are both owned by Vinings Marine. There is a price difference between the 2 marinas. They offer both slips and dry storage. It is a quick trip to...

I always wanted a 1970 Dodge Challenger the same as in the movie "Vanishing Point." I almost bought one when I was in high school. It had a 383 six pack with Hurst 4 on the floor, air shocks but.. I probably would have killed myself in it. Too much power!!

October? Just in time for striper season. It gets a little crazy at this time by the CBBT. Good luck with your move.

Done

Great post(s). i am planning on installing a kicker on my Parker. Where did you get the bracket? Joe

You might think I am a little crazy but here is an idea to try. Get a piece of square stock 1" x 1" (or 1 1/2 x 1 1/2). Rip it in half. Use a router to cut a groove in the wood for the wiring. Glue it back together and then put it on a lathe to make it round. You now have a basically a...

I keep mine in the ditch bag hanging on the back of the seat.

I believe I put a response on THT about this. I used the foam gasket supplied with my radar mount to act as a type of "shock abosrber" to reduce vibration on the radome. I put 4200 around the bolt holes to prevent water intrusion in to the roof of my pilothouse roof.

It was 15 oz per gallon but that changed several years ago.