I own an EZ-Loader tandem trailer that has torsion axles. Although they appear to be working fine the torsion bars are severely rusted. Any recommendations on when or if they should be replaced. Thank you.
While fishing in the Chesapeake I hit something underwater and took some chunks out of the front of the skeg on my 150 yamaha. There is no oil leakage and I can detect no vibrations. Question: what to do? One repair service, without seeing the motor, said they would pressure test it and if ok...
My trim Indicator on my Yamaha controls (150 4-stroke) does not function properly. The bar stays near the top of the display and oscillates a bit. It continues to do this no matter what trim I place the engine. Any suggestions as to the cause. Thank you.
I'm sure this has been covered before but please indulge me. Is there any concern about mixing gas containing ethanol with non-ethanol gas? I am down to 27 gallons of ethanol gas in my 23se and want now to add non-ethanol gas.
Thank you.
I believe my bunks are set up properly; they are outside the chimes and they do not extend beyond the transom. My trim tabs are recessed and are under the stern; not attached to the rear of the stern. Unless the boat is centered perfectly the edges of the tabs cuts into the bunks on one side or...
The guide posts pictured are all plastic (pvc). Since the front of the boat is wider than the stern will they give as the boat goes on the trailer? The bunks run the entire length of the boat.