Search results

Sold.

Dutton-Lainson Strongarm SA9000 12 volt electric winch. New, never used. $250.00

yes,these are ladder back chairs.

For Sale: Captain chairs (2) from a Parker 23SE. Excellent condition. Were replaced by a leaning post. $150.00 each.

How does one determine spindle size? I have an EZ loader tandem trailer (4700#) with torsion axles. Anyone the size of the spindles? Thanks.

Canvas connection, Deale, Md.

I own an EZ-Loader tandem trailer that has torsion axles. Although they appear to be working fine the torsion bars are severely rusted. Any recommendations on when or if they should be replaced. Thank you.

Thanks Dale. The prop did have a few minor abrasions along the edges of 2 of the blades.

While fishing in the Chesapeake I hit something underwater and took some chunks out of the front of the skeg on my 150 yamaha. There is no oil leakage and I can detect no vibrations. Question: what to do? One repair service, without seeing the motor, said they would pressure test it and if ok...

Thanks guys. Plastic cam was broken.

My trim Indicator on my Yamaha controls (150 4-stroke) does not function properly. The bar stays near the top of the display and oscillates a bit. It continues to do this no matter what trim I place the engine. Any suggestions as to the cause. Thank you.

Tri-State in Deale, Md. is not that far from you. They have it.

I'm sure this has been covered before but please indulge me. Is there any concern about mixing gas containing ethanol with non-ethanol gas? I am down to 27 gallons of ethanol gas in my 23se and want now to add non-ethanol gas. Thank you.

I believe my bunks are set up properly; they are outside the chimes and they do not extend beyond the transom. My trim tabs are recessed and are under the stern; not attached to the rear of the stern. Unless the boat is centered perfectly the edges of the tabs cuts into the bunks on one side or...

The guide posts pictured are all plastic (pvc). Since the front of the boat is wider than the stern will they give as the boat goes on the trailer? The bunks run the entire length of the boat.

I have a 23se which I transport with a bunk trailer. I have difficulty lining up the stern on the trailer when retrieving it at a ramp. I have to be fairly exact or the edge of the trim tabs cuts into the bunk. I'd appreciate any suggestions on ways to align the stern. Thanks.

I had the same problem and, like you, I was unable to get rid of the stain.I even tried wet sanding.

I also have one for my 150. Works well.

Our community on the eastern shore of Md. has a marina and a decision has been made to convert from ethanol to non-ethanol fuel. A local marine mechanic has stated in our local newspaper that a mixing of the fuels in a boat's fuel tank could cause engine problems. Is there any validity to his...

I think you are right. I have not made any measurements but I did put a level on the end of the tongue and it was level. However when I placed the level on the frame at the front tire it indicated that the trailer was angled down at that point putting more weight on the front tires. I have...